|
AMF Bowling Ball Drilling Pattern #3
Drilling Pattern # 3
- Locate the mass bias and mark the spot with an 'MB.' Remember, the mass bias is a fine tuning device used by advanced players.
- Place the major pin 3-3/8" from the PAP and locate the mass bias halfway between the player's ball track and PAL.
- Place the extra hole, if necessary, on the player's PAP, removing excess side weight to less than an ounce.
- NOTE: This is a "High Flare" layout and should only be used by low rev players seeking maximum ball reaction!
- This layout is ideal for long/or heavy oil conditions for when you need the ball to break into a hook earlier than your other equipment.
All Ball Drilling Patterns | AMF Patterns
|
