DUAL ANGLE LAYOUT TECHNIQUE™ - Layout Method (Part Two)

Pin-PAP Line Now draw the Pin to PAP line by using the scale of the Pro Sect® to draw a line from the pin through the marked drilling angle. This completes the marking of the drilling angle on the ball to be drilled. (Upper Left)

The next step in completing a DUAL ANGLE layout is to measure and mark the distance from the pin to the PAP on the Pin to PAP line by using the scale of the Pro Sect®. (Right)

PAP Marking

 

VAL Angle Measurement

 

Next, measure and mark the angle between the Pin to PAP line and the VAL by placing the zero point on the scale of the Pro Sect® on the PAP and the rib on the Pin to PAP line. Now measure and mark the angle to the VAL using the protractor. (Lower Left)

 

  

 


 

DUAL ANGLE LAYOUT TECHNIQUE™

1 - Introduction to Dual Angle Layouts

2 - Core Comparisons (Asymmetrical/Symmetrical)

3 - Reasons for Drilling Angles

4 - Pin/PAP Distance Information

5 - Track Flare Information

6 - Reasons for Angle to VAL

7 - Layout Method (Part One)

8 - Layout Method (Part Two)

9 -  Layout Method (Part Three)