Layout 1
This is the recommended layout for most players.
If you do not have a positive axis, use this layout.
- Ball Reaction: Long and Strong
- Suitable for: Most Styles and Lines
- Flare Potential: Medium
- Center of Gravity: The center of gravity placement may or may not fall inside the CG Area. If it doesn't then the balance hole location may need to be adjusted.
- Mass Bias Placement: Place Mass Bias 3 inches to the right of the thumb hole If needed place balance hole 4 inches over and 1/2 inch up and drill back to statically legal.
Layout 2
This is the recommended layout for most players that have known axis measurements
- Ball Reaction: Long and Strong
- Suitable for: Most Styles and Lines
- Flare Potential: Large
- Pin Placement: Place Pin 4 1/2 inches from PAP
- Center of Gravity: The center of gravity placement may or may not fall inside the CG Area. If it doesn't then the balance hole location may need to be adjusted.
- Mass Bias Placement: Place Mass Bias at a 45 degree angle to the right of the thumb hole. If needed place balance hole over on the Vertical Axis Line and 2 inches down and drill back to negative side weight. The bigger and deeper the hole is the more increased ball reaction. Remember to keep the ball statically legal.
Layout 3
This is the recommended layout for most players that have known axis measurements.
This layout produces the most even reaction with the highest total hook.
- Ball Reaction: Early and Strong
- Suitable for: High Ball Speed, Low RPM, Heavy oiled lanes
- Flare Potential: Very Large
- Pin Placement: Place Pin 3 1/2 inches from PAP
- Center of Gravity: The center of gravity placement may or may not fall inside the CG Area.If it doesn't then the balance hole location may need to be adjusted.
- Mass Bias Placement: Place Mass Bias in line with the Pin. If needed place balance hole over on the PAP and drill back to statically legal.
Layout 4
This is the recommended layout for All Full Rollers
- Ball Reaction: Strong Arc
- Suitable for: Most Styles and Lines
- Flare potential: Large
- Pin Placement: Place Pin 3 1/2 inches from bowlers center of span in an 8:00 direction
- Center of Gravity: The center of gravity placement may or may not fall inside the CG Area. If it doesn't then the balance hole location may need to be adjusted.
- Mass Bias Placement: Place Mass Bias at a 2:00 direction from the center of span. If needed place balance holes 8 inches from the center of span in a 2:00 direction to remove excess positive side weight. Place balance hole 6 inches from the center of span in a 8:00 direction to remove excess negative side weight.
Layout 4
This is the recommended layout for All Full Rollers
- Ball Reaction: Strong Arc
- Suitable for: Most Styles and Lines
- Flare potential: Large
- Pin Placement: Place Pin 3 1/2 inches from bowlers center of span in an 8:00 direction
- Center of Gravity: The center of gravity placement may or may not fall inside the CG Area. If it doesn't then the balance hole location may need to be adjusted.
- Mass Bias Placement: Place Mass Bias at a 2:00 direction from the center of span. If needed place balance holes 8 inches from the center of span in a 2:00 direction to remove excess positive side weight. Place balance hole 6 inches from the center of span in a 8:00 direction to remove excess negative side weight.
Print this layout