• Ball Motion - Length with aggressive backend
• Lane Condition - Medium to Heavy Oil
• Flare Potential - High (5"+)
• Pin Placement - Place pin at 4 1/2 - 5 1/2" from the positive axis point (PAP)
• HART Placement - Place HART in or near the ball track keeping side weight and finger/thumb weight to less than 1 ounce

NOTE: For bowlers with higher rev rates, place the pin at 5 - 5 1/2" from the bowler's positive axis point.
For bowlers with lower rev rates, place the pin at 3 1/2 - 4" from the positive axis point

• Ball Motion - Controlled arc (about 4-6 boards less than Drilling #1)
• Lane Condition - Light to Medium Oil
• Flare Potential - Medium (2-4")
• Pin Placement - Place pin at 5 - 5 1/2" from the positive axis point (PAP)
• HART Placement - Place HART 1" right ofthe ball track keeping side weight and finger/thumb weight to less than 1 ounce

• Ball Motion - Excellent length with smooth arc (about 6-8 boards less than drilling #1)
• Lane Condition - Light Oil
• Flare Potential - Low (0-2")
• Pin Placement - Place pin at 5 - 5 1/2" from the positive axis point (PAP)
• HART Placement - Place HART 3" right of the ball track
• Balance Hole - If needed, place the balance hole 4" from the center of the span on a line through the center of gravity

• Ball Motion - Length with aggressive backend
• Lane Condition - Medium to Heavy Oil
• Flare Potential - High (5"+)
• Pin Placement - Place pin at 4 1/2 - 5 1/2" from the positive axis point (PAP)
• HART Placement - Place HART in or near the ball track keeping side weight and finger/thumb weight to less than 1 ounce